October 16, 2015 at 4:47 am #22248
No. The problem is that I made the drawing with a photo with stiplegen2 and export it to Inkscape. I see in Inkscape the eyes black but when I print the eyes are white (with less concentration of points, so they looks white)
On the other hand, I open a photo of a face with Inkscape and vectorice in gray scale. In eggbot contributed I make the layers. I want to fill the regions and use the “hatch fill” but some lines fall outside the region and I can,t delete. When I use the rubber all the image disappears!
Thank you again