Home › Evil Mad Scientist Forums › Egg-Bot › Some print problems with my EggBot › Re: Some print problems with my EggBot
November 28, 2015 at 3:23 pm
#22302
Bob2299
Participant
I tried using hatchfill and it did the job, but did not print well. The outline printed, then the hatchfill printed but out of register (about 1/8″ lower down the image) and added to print time.
I do not see any slippage of the egg or misssing or added stepper motor steps.
Any suggestions as to why and how to correct this?
In searching the site I found a suggestion to set outliine and hatch as 2 separeate layers and just print the hatchfill. Is this a good solution, it does seem to add a lot of complexity.