Reply To: AxiDraw fell off. What should I check ?

[Bruno]

Hi !

Just checkin in lately to thank you a lot for your rich and exhaustive answer. I finally did a full checkup. I noticed two things :

– When I move the carriage on the X axis by hand slowly, the Y axis tends to move back and forth, sometimes by several centimeters, depending on the movement speed.
– One feet is very slightly rocky when I push on top of it, which makes sense : according to the hole in my floor, it pretty much may be the foot that absorbed the fall.

Should I take caution to one of these symptoms ? Either way, I’ve tried some new plotting and the results look as fine as before. I guess the machine is as sturdy as it’s advertised it is :)

Thanks a lot once again !

Bruno

• This reply was modified 5 years ago by Bruno.