Re: about Tennis For Two on scope

Home Evil Mad Scientist Forums Microcontrollers about Tennis For Two on scope Re: about Tennis For Two on scope

#21252
dr.wily
Participant

I feed with 5v provided by a PC PSU, but I can test with batery.

Ground connection is OK, my multimeter show 0 ohm everywhere on ground circuit

When no buttons are pressed the ball don’t move, floats and falls automatically after 30s.

I wonder if it comes from pot. I bought this one : http://www.newark.com/bi-technologies-tt-electronics/p160knp-0qc20b10k/potentiometer-linear-10kohm-200mw/dp/34R4721?Ntt=1760793

I plug wires like this :

– brown (ADC) in center
– green (GND) at left
– orange (VCC) at right with 10k resistor

On button :

– blue (PC) with 10k resistor
– green GND

V+ is independent on each paddle or can I use one V+ for both ?