Home › Evil Mad Scientist Forums › AxiDraw › Drawing Diagonally when using CNCServer › Re: Drawing Diagonally when using CNCServer
February 13, 2017 at 4:19 pm
#22845
blin
Participant
I am using Postman to get and put the “botType,” but even though I changed the botType to axidraw, it is still drawing on a diagonal. Is there anything else we need to change it to AxiDraw mode?
I am also looking at the RoboPaint GUI. It appears that there are only two modes: WaterColorbot and Eggbot.
