Home › Evil Mad Scientist Forums › AxiDraw › Drawing Diagonally when using CNCServer › Re: Drawing Diagonally when using CNCServer
May 12, 2017 at 1:35 pm
#22847
cojovo
Participant
I’m having this issue using RoboPaint. Using 0.9.5 I can easily send svgs to print but they print at 45 degrees and there’s no botType option.
Using the newer v2 betas the option is available but I can’t get any of the options to work, just spins the white dots.
What is the version where the axidraw option was included so I can try going back to that one?