Re: Engraver will not start help needed

Home Evil Mad Scientist Forums Egg-Bot Engraver will not start help needed Re: Engraver will not start help needed

#23010
Windell Oskay
Keymaster

What I had intended to suggest is that you open an EggBot File, and try to plot it _with the EggBot software_ with its engraver control enabled, but _while connected to the AxiDraw_ (and, critically, with the AxiDraw at the middle of travel in both X and Y). Would you please give that a try?

Side note: The error message that you received is normal and expected (though ugly, and nicer looking in forthcoming versions) — it’s what I’d expect you to get if you try to plot an EggBot file with AxiDraw Control.