Home › Evil Mad Scientist Forums › Other kit and product support › Flickery Flame – 3 kits in serial? Powered by AC? › Re: Flickery Flame – 3 kits in serial? Powered by AC?
October 13, 2016 at 10:58 am
#22541
RickB
Participant
I built the same circuit as pinballdude using the flicker flame kits and the bridge rectifier circuit on a prototype board. Is it possible to change out the leds on the flicker flame kit to get a “bubbling green” effect? If so, do the resistor values need to change (I switched to 150 ohms per the above discussion)?