Multiple Plot Error

Home Evil Mad Scientist Forums AxiDraw Multiple Plot Error

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #28291
    MDU
    Participant

    I draw a basic shape then use the Axidraw Utility ‘hatch Fill’ extension. When I print it goes over the same plot three times. Any assistance to reduce this to one would be greatly appreciated (driving me slowly mad). This has happened to me for other images but this is the simplest example I can give. Many thanks in advance, Mark

    #28292
    Windell Oskay
    Keymaster

    If the whole document is plotting three times, check that you have only one copy selected in the Plot tab.

    If only this shape and its fill are plotting three times, then either:
    * You applied Hatch Fill three times,
    * You applied Hatch Fill and then duplicated the results, or
    * You had three shapes selected before you applied Hatch Fill.

    Without looking at the file, it’s not possible for us to advise which the case is.

    #28293
    MDU
    Participant

    Thanks Windell, I looked at each layer and indeed found multiple fills. Not quite sure what has happened but I will have to slow down my clicking finger. Many thanks as always for your quick response. Mark

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.