Need advice

Viewing 1 post (of 1 total)
  • Author
  • #28534

    Hello guys, I am jamesbills. New joined member.

    I am living in USA and have small shop there. I need your help in getting a review on a product. .

    I am looking for a GRBL controller that work easily with Lightburn .

    After some searching i got recommendation of 3 Axis 1.1f Laser Control Board USB GRBL Controller from this article :-
    After reading i found it quiet good as it has ability to control laser and spindle at the same time, it also supports offline control. And laser configuration is 12V that makes it perfect to work with.

    So, i think it will be good but want to know previous customers reviews. Therefore if you used it previous then it will be helpful to know your thoughts on it whether it works easily with Lightburn or not.

    Any other recommendations are also useful.

Viewing 1 post (of 1 total)
  • The topic ‘Need advice’ is closed to new replies.