Forum Replies Created
-
Posts
-
Got it.I will populate every rows, thanks.
Yes I left several rows. Was that cause the error?
Yes.I just bought this panel few weeks ago.
I looked the instruction, and checked my panel, jumpers were installed on JP3 & JP4
Is this setting correct?
Sorry I am not sure what’s “SER” and “P2” mean…
But I can say the error line also went wrong during testing with Peggy2 example
http://www.youtube.com/watch?v=cz_1aiioaG8&feature=plcp
The top line of green part was brighter than other row
Thanks A lot. It works!
But I got a new problem. Some bulbs were out of control, I didn’t draw it at some frames, but it still glowing
not sure which part going wrong..lol
Ps. Those error bulbs were on the same row, and also brighter than other bulbs
HI I think I had some related problem.
I had installed the Peggy2 library (I can run the example on Peggy2 successfully)
Then I drew some animation and open it with Arduino, but it shows error like
” AnimationFrames” doesn’t named a type
Don’t know where goes wrong!
